עדיין מחפשים עבודה במנועי חיפוש? הגיע הזמן להשתדרג!

במקום לעבור לבד על אלפי מודעות, Jobify מנתחת את קורות החיים שלך ומציגה לך רק משרות שבאמת מתאימות לך.

מעל 80,000 משרות • 4,000 חדשות ביום
חינם. בלי פרסומות. בלי אותיות קטנות.

חברה בתחום כללי

תל אביב - יפו

חברה בתחום כללי

תל אביב - יפו
מלאה
18,000-26,000 ₪ (הערכה מבוססת AI)
הערכה מבוססת AI ולא שכר של המעסיק

We are looking for a hands-on Hardware Design Engineer to own the full hardware lifecycle - schematic capture, PCB layout, mixed signal circuit design, power architecture, bring-up, and regulatory certification - across current and next-generation hardware.

Responsibilities

Digital Hardware Design - MCU, PHY, Ethernet & PoE

Design the complete digital hardware stack: NXP i.MX RT MCU schematic and BGA layout, Ethernet PHY circuit and controlled-impedance Ethernet routing. Design and validate the IEEE 802.3af PoE front-end : PD handshake, mid/end-span bridge rectifiers, isolated flywheel buck , and optocoupler feedback regulation; analyse cross-domain IO level margins across all MCU interfaces to confirm safe driver/receiver operation.

RF & Analog Circuit Design

Design the ISM transmit chain and 2.4 GHz AoA receive chain; simulate match networks with ADS or equivalent and validate with VNA S-parameter measurements.

PCB Design & Layout

PCB layout: Define stack-up and controlled-impedance rules; route high pin-count BGAs and high-speed peripherals with length tuning; partition RF, digital, and power domains for FCC/ETSI compliance.

Power, calibration & test: Design DCDC/LDO supplies and power distribution; define hardware test procedures for RF power and frequency calibration at production.

Production Support

Failure analysis (field & manufacturing)

Yield improvement

Cost reduction

Post-Silicon Verification Support

Requirements:
B.Sc. in Electrical Engineering - mixed-signal focus.

3-5 years of hands-on PCB design experience for production hardware of analog and digital design, including 2 years with RF circuits at 900 MHz and/or 2.4 GHz.

Proficiency in Altium Designer or OrCAD/Allegro for multi-layer high-density layout: controlled impedance, differential pairs, and RF routing.

Experience with multi-domain power architectures: DCDC converters, LDOs, power sequencing circuits, and IO level compatibility analysis.

Experience digital hardware stack: NXP i.MX RT MCU schematic and BGA layout, Ethernet PHY circuit.

Solid RF fundamentals: S-parameters, impedance matching, Smith chart, link budgets, directional couplers, as well as LNA and PA operation.

Hands on experience with lab equipment: oscilloscope, logic analyser, VNA, and spectrum analyser.

Familiarity with EMI/EMC design practices and experience supporting hardware through FCC, CE, or equivalent certification.

Advantage

Experience with angle of arrival concepts (such as BLE AoA) and the associated hardware design/constraints.

Experience with NXP MCUs hardware constraints.

Experience designing PoE (IEEE 802.3af/at) and isolated flywheel buck power delivery circuits.

Experience with HyperRAM and high-speed PCB design.

Experience with Ethernet hardware design and manufacturing RF test fixtures.

This position is open to all candidates.